I know Polycoms can be troublesome and probably not the best choice ( our SNOMs are less an issue ) but we have 40 of them - some are working and most are not - but I am not hooking them up until I can figure this out… why have all the phones not working ? They worked via VPNs for years in our remote locations anjd all our offices. I shut down Fail2Ban for 3 hours today - and I was able to ping these phones via the VoIP CLI - but they just refuse to register STILL !! I am at the point where I need to get a definitive answer – these phones are vital to us as we are contractors for various military installations. I have a updated phone with a greaat GUI that won’t register. I took a chance on ONSIP and it seemed to work. I found ONSIP by reading pages and pages of posts with people with similar issues. When the phone booted it started downloading and installing new Firmware and Software and when it completed that I was presented with a more useful GUI with all kinds of info and config options. A lot of these phones are in remote offices and they do not have the same nice GUI but the older one ver 3. If there is a better method to wipe / reset/ and update - I am all ears ( or eyes ). I tried but it just kept rebooting itself. I could not find a better way to reset and update than ONSIP. I figured it would wipe out any “stuck” auth info and let me start over. Only on One ( 1 ) phone did I use ( ext 111) because I wanted to Factory reset the phone and update it to see if that was an issue with it being blocked. All the CLI shows is Failed to Authenticate.Īll these phones worked fine on previous VoIPs OK - So now what do I do to find out WHY they are being thrown into Banned what can I do to stop this from happening ? I don’t understand one comment dicko made about a Bad Auth - I tripple checked the settings and made sure the passwords matched in FreePBX Extensions and in the Phone’s GUI and even setting up the Phones on the phone’s keypad on the one unit I had sent to me.Īll SNGREP tells me is 403 forbidden - or failed. I am tempted to just shut down Fail2Ban entirely and rely on our Firewall but I am reading about a Hack that seems to affecting FreePBX and Digium phones etc. I then asked local users to replug in the Lan cable and as soon as the phones boot up, they pop right into the Banned list !! They are in Both places ! I Stopped Fail2Ban - I made the entries by Removing them from the Banned section and placing them in the Whitelist section - Then Restart Fail2ban. I still do not know why the phones I am trying to register keep appearing in the BANNED IP section of Fail2Ban AND they are specifically listed as a Whitelisted IP and the network they are on is ALSO Whitelisted. I have been going over everything here and tripple checking settings etc etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |